The Attic Renovation: Installing Collar Ties

The Attic Renovation: Installing Collar Ties

After I completely gutted the attic, I had a blank slate. My primary concern was ensuring the attic had proper insulation and ventilation. Installing collar ties was a necessary step.

Basic Attic Structure

Attic diagram courtesy of Used with permission.

This diagram shows the basic structure of a finished attic in a 1½ story house.

The vertical studs are what is commonly referred to as the knee wall.  The knee wall meets with the slope of the roof which creates a cathedral type sloped ceiling.  The space on the other side of the knee wall is the side attic.  The diagram also illustrates the use of styrofoam insulation which is an idea from Jon Eakes’ website which I incorporated into my own renovation.

Installing Collar Ties

I installed some collar ties so I could insulate the ceiling while leaving an air space at the top of the attic for ventilation.  The ties allow for a drywall ceiling and add strength to the roof structure.

I temporarily attached a couple of 2x4s to the rafters and made sure they were level to each other and along their lengths.  I then cut 2x6s and installed them by resting them on the 2x4s and screwing them to the rafters.  The 2x6s allow for R-20 insulation.  An additional R-5 will be provided by extruded polystyrene boards which will be sandwiched between the collars and the drywall, providing a thermal break.  I was advised against adding another layer of insulation above the collar ties as the resulting air space would be inadequate.

If I had to do it over again, I would install the collar ties lower to allow for the extra layer of ceiling insulation and I would use  thicker foam board insulation. We have found the second floor temperatures in the summer to be about three degrees (Fahrenheit) warmer than the main floor.

Encapsulating minor fire damage

Before tackling the collar ties, I had to take care of a small surprise that came to light when I gutted the attic. At one time, there had been a fire in the side attic of the smaller bedroom. You’d think this sort of thing should have been disclosed by the previous owner, but we have no such disclosure laws here. The fire damage is obvious in these pictures, and fortunately was limited to only the surface of the timber. I painted over the fire damage with Zinsser Bin spray primer which supposedly helps to encapsulate any odor. This step may not have been necessary since the damaged wood will be sealed behind vapour barrier (there was no detectable odor before), but this preventative measure required less than $20 and about 10 minutes of time.

The Attic Renovation

Leave a Reply

Your email address will not be published. Required fields are marked *